how to install canon mx320 printer without disc

Insert the CD that came with your printer and run the setup. If the WPS wireless setup is still failing after following this guide, please contact us for further assistance.ġ. If you do not have the installation CD that came with your product, please download the manuals and software to continue. Please now proceed by installing the software to make the most out of your PIXMA MP495. When referring to the printout, check that the “Link Status” indicates “Active” and that the SSID - Service Set Identifier (the name of your wireless network) indicates the correct name of your wireless network. Press the button (A) repeatedly until the LED displays. Load a sheet of A4 or Letter-sized plain paper.ģ. Make sure that your printer is turned on.Ģ. To confirm that your printer is successfully connected to your wireless network, you can print out the network settings of your printer:ġ. If you have more than one access point, press the button on only one access point. Please wait for a while, then conﬁgure WPS settings again. This error appears when multiple WPS access points are detected. Is the access point turned on? If the access point is already turned on, turn it off, and then turn it back on.

This error appears when wireless connection setup was not completed within 2 minutes after pressing the WPS button. If any of the following error codes are displayed on the LED (alternately flashing between the letter “E” and then a “Number” followed by another “Number”), please press the or button to dismiss the error, and then repeat steps 1 and 2. Make sure that the (blue) Wi-Fi lamp on the printer is also lit. When wireless connection is complete, the LED lights up for about 3 seconds, then changes to '1' as shown in the illustration below. The (blue) Wi-Fi lamp on the printer will ﬂash while searching for, or connecting to the access point.ģ. Make sure that the LED ﬂashes as shown in the illustration above, then press the button on your access point within 2 minutes.įor exact details regarding pressing the WPS button, please refer to the access point manual. Make sure that the LED ﬂashes as shown in the illustration below.Ģ. Press and hold the button (A) on the printer for approximately 5 seconds.Ģ. If the power is on, the LED (Light Emitting Diode) is lit as shown in the illustration below.ġ. Most WPS enabled access points use this protocol. Your network must be using the WPA (Wi-Fi Protected Access) or WPA2 security protocol.If the WPS push button is not available please use the instructions in the Standard Connection Method section. Please check with your device’s user guide for details. The access point must have a physical WPS push button available.

Before we start, there are some conditions that must be met in order to use the WPS push button method:

How to install canon mx320 printer without disc